J100-3D Einleitungs-Schmierpumpe mit Druckentlastung
J100 lubrication pump is highly efficient and easy to operate. It is designed for small and medium-sized machinery. It has a variety of capacities and multiple ways of refilling. It can form a single-line centralized lubrication system and a progressive lubrication system.
Beschreibung
Merkmale
– The J100 lubrication pump is driven by a motor to drive the piston pump to move back and forth to deliver grease to the pump outlet, and then to the lubrication point through the pressurized distributor. When the preset pressure is reached, the motor stops working, and the pressure relief valve starts working accordingly, releasing the pressure in the system, and a cycle is completed.
– The lubrication pump can be controlled by an external control system, which mainly sets the lubrication frequency, connection time and interval time.
– The system pressure can be monitored by a pressure switch, which is usually installed in the oil pipe of the last distributor. When the pressure switch sends a signal to the control unit, the signal stops the pump.
– The maximum pressure of the J100 lubrication pump is 8MPa, the minimum lubrication interval is 5 minutes, and the main line length is 15 meters. It is suitable for small and medium-sized equipment with up to 100 lubrication points for indoor use.
Spezifikation
| Modell | J100-3D |
| Schmierzeit | PLC or external controller |
| Intervallzeit | PLC or external controller |
| Betriebstemperatur | 0℃~ +50°C (Low temperature conditions require antifreeze grease) |
| Anzahl der Filialen | 1 or 2 |
| Reservoirkapazität | 0.3L, 0.5L, 0.7L, 1.5L |
| Nachfüllen | Filling port/removable/cartridge |
| Schmiermittel | NLGI 000#~2# |
| Pressure relief valve | Optional |
| Entladung | 15 mL/min |
| Max. Betriebsdruck | 8.0 MPa |
| Anschlussgewinde | Auslass Φ6 |
| Betriebsspannung | 24 V Gleichstrom |
| Zertifizierung | CE |
| Niedrigniveauschalter | Öffner |
Montage
– Fix the lubrication pump on a vertical and flat surface that can fully bear the weight of the pump.
– Install and fix the lubrication pump with 6 M8 bolts through the φ9 holes.
– It is recommended to apply anti-vibration glue when the lubrication pump is subject to vibration.
– Install the lubrication pump in a location that is isolated from water, oil, chips and dust.
– The vibration of the installation location needs to be 9G (88m/s2) or less.
– On the electrical connection of the lubrication pump unit, make sure to take appropriate measures to prevent interference between signals due to inductance, capacitance or electromagnetic coupling. Although the cables are placed separately, use anti-interference cables in places where electrical interference fields can distort signal transmission.
